Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

Sharpening a skew - using a jig - like Terry Scott

Posts

Sharpening a skew - using a jig - like Terry Scott

#1

Sharpening a skew - using a jig - like Terry Scott

Craig Daymon

Watching Terry Scott's video yesterday and one thing that really stuck (lots of good stuff in all) was the way he sharpened his skew with the Tru-Grind jig. Can this be done with a Wolverine jig? I presume it is only good for relatively small skews with a Wolverine, if at all.

Re: Sharpening a skew - using a jig - like Terry Scott

#2

Re: Sharpening a skew - using a jig - like Terry S *LINK*

John Lucas

Haven't seen TErry's video but here is how I do it.


https://www.youtube.com/watch?v=MJYNLkPh_LM

Re: Sharpening a skew - using a jig - like Terry Scott

#3

Re: Sharpening a skew - using a jig - like Terry S

Craig Daymon

Thanks John. Nice video. Though I can sharpen a skew. After all, it's probably the easiest tool to sharpen.

What I liked was the way Terry Scott sharpened it using the Tru-Grind jig and was interested if anyone had tried the method with a Wolverine/Vari-Grind setup.

Re: Sharpening a skew - using a jig - like Terry Scott

#4

no need to grind. just hone with diamond 


Re: Sharpening a skew - using a jig - like Terry Scott

#5

Eventually you do have to grind.

John Lucas

I grind my skews with a concave bevel so that you are only honing a small contact area. However the contact area gets bigger and bigger so sooner or later you regrind the concave.

If you use a flat bevel you could hone a micro bevel but it's also going to get bigger and bigger and you eventually have to grind the whole flat area.

If you use a convex bevel you might be able to hone for a good while but you would be honing the whole bevel because if you just hone the tip is seems to me like you gradually be making the tip more round or more blunt until it would not cut correctly.

Re: Sharpening a skew - using a jig - like Terry Scott

#6

Brad Vietje

Re: Sharpening a skew - using a jig - like Terry S

Brad Vietje

Nice video, John.

That's a very clear explanation, and a nice little jig, too. Looks like your 2" belt runs downward, but seems to work quite well.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Sharpening a skew - using a jig - like Terry Scott

#7

sure but not to SHARPEN