Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Think this will fit in my shop *LINK*

Posts

Think this will fit in my shop *LINK*

#1

Think this will fit in my shop  *LINK*


http://roanoke.craigslist.org/tls/3485633527.html

Re: Think this will fit in my shop *LINK*

#2

Where??? 

Re: Think this will fit in my shop *LINK*

#3

JL

Sure

JL

It's about a car length long. But are you planning on turning columns or something?

Re: Think this will fit in my shop *LINK*

#4

Re: Think this will fit in my shop

Keith Newton

I wouldn't bother going to the trouble if it were across the street, and free. While yes, it may have a motor that will turn it, and you could mount something that long over the bed. My estimation, is that unless the blank started out perfectly balanced, it would shake all over the place, and even if the work was finally balanced, the cutting action itself would set up harmonic vibrations in those long steel beams.

I would want massive cast iron for one that size. Even then, do you think that you would want to go into business turning columns of that size by hand, and try to compete with shops that have automatic lathes. This is one of those times where you have to be careful what you wish for.

Re: Think this will fit in my shop *LINK*

#5

I was going to turn tooth picks.   


Re: Think this will fit in my shop *LINK*

#6

Rob Wallace

NOW you have to move the bandsaw!


Re: Think this will fit in my shop *LINK*

#7

Jim Barbour

Re: Think this will fit in my shop

Jim Barbour

Now you can turn that 12 foot trembleur you've always wanted to make!

Re: Think this will fit in my shop *LINK*

#8

Re: Think this will fit in my shop

Bob Macgregor

Buy that and fabricate a couple of steady rests and you'll be ready for EXTREME FINIAL TURNING!

BOB