Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Drive problems Jet 1442

Posts

Drive problems Jet 1442

#1

Drive problems Jet 1442

walt cheever

My Jet 1442 is about 7 years old, with a Reeves drive. I discovered that I had no torque above 1200 rpm, and when I checked the drive pulleys, found that the split pulley on the motor shaft wouldn't close all the way. A quick conversation with Jet technical support suggested that the keyway in moving half of the pulley had distorted, and I needed to replace it.

I pulled the old pulley off, and that was indeed the problem, and the replacement was fairly easy (it needed 4 hands however) and my machine works well. I learned a few things I'd like to share.

If this happens to you and you are buying new pulleys--buy a replacement shaft key as well. It's good insurance. Mine was distorted, but when I turned it over it looks like it will work. (fingers crossed.)

I had lubed the shaft with graphite, to avoid attracting dust. Tech Support said that most people who call with my problem had used graphite-they strongly recommend using oil, then cleaning out the junk yearly.

The end of the motor shaft seems to have a lube fitting in it, and there is a lube hole in the shaft that happens right under the moveable part of the pulley. The end fitting has some sort of spring mounted closure, sort of like a zerk fitting, but without the rounded part that a grease gun grabs. It would be a wonderful way to get a bit of lube right where it's needed, but I can't figure out how to get it past the closure.

I called Tech Support about that, they had no idea about what the fitting was for or how to use it. Their suggestion is to put in drops of oil with a long spouted oiler. Has anyone else figured out how to use that fitting?

Anyway--I back to turning, and pleased about it.

Re: Drive problems Jet 1442

#2

Ellis Walentine

Thanks, Walt

Ellis Walentine

No help on the Zerk fitting, but thanks for bringing these issues to people's attention.

Glad you're back in business.

Ellis Walentine, Host