Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Experimenting With Turned Lampshades #2

Posts

Experimenting With Turned Lampshades #2

#1

Brad Vietje

Experimenting With Turned Lampshades #2

Brad Vietje

So here's the second attempt, nearly 3 years later... apologies for the awful photo!

I found some spalted Poplar on a back road where a tree had fallen after Hurricane Sandy blew through Northern VT... Not sure if it was a Big Tooth Aspen, Balsam Poplar or other close relative, as I found the trunk cut into 4' lengths in a jumbled snow-covered pile where the road crew cut it up to get it out of the road. Had enough spalting and center rot that I was not sure if it was too far gone.

The Shade was NOT turned to match the lamp on which it sits -- that's just to get some light shining through it. All we have at home are 15- and 20-watt CFL's and a few LED's, so I may need to place it over a 100 watt incandescent to get a better image; this looks pretty dark here.


Turned OK, though it was quite punky toward the center. Nice color streaks, lots of bug holes, and a few knots, too. These are very hard to photograph, and I don't have access to good photo editing software on my home computer. I can improve the photos with a tripod, but haven't broken that out yet. I hope you can get the gist of it.

I need to figure out how to part these off, and how to plan the process so I can get a nicer shape, too. This was originally going to be taller, but I was at the limits of what I could reach with the tool rests I have. I'd like to preserve good strength where the shade meets the mounting hardware, and still get a pleasing shape. I'll have to check with Peter Bloch down in New London, NH for how he does this.

Safe spinning,

Brad Vietje

Newbury, VT