2 different tables. The one table was made from all thread rod with a nut on it to adjust the height. You don't really need that. I did that so I could use it on different lathes when I demo. It's also handy for getting spiral looking cuts on turnings. If you make a straight cut from the outer edge to a slightly raised middle and your above or below center it appears to be a spiral.
On the one with the smooth post I simply use PVC pipe spacers to give me the dead on center cut that I use for most work using the router.
Nice and simple design, John -- now I need to make one, too. I won a router in a contest here at W/C about 2 - 3 years ago, and this will allow me to use it for fluting bowls, spindles and such. Thanks for the photos.
Safe spinning*,
Brad Vietje
Newbury, VT
* almost posted "Safe sinning" once again ! ;~) Seems on my older computer at home, the "P" key needs cleaning... what a hoot!