Re: OK now I feel stupid
David Walser
Mike,
The blank starts out as a cube. If you have a cube -- even a Rubick's Cube -- take it out and follow along. Set the cube on a flat surface in front of you. Now tilt the cube until on of the corners is pointing straight up and the corner opposite is resting on the flat surface. Put your index finger on the corner pointing straight up. You should be able to spin the cube on the axis that runs between the two corners (points) of the cube. Imagine your index finger is the headstock and the flat surface is the tail stock. This is how the blank will be oriented on the lathe.
Notice that when you spin the cube, three of the corners spin on a plane that is perpendicular to what would be the ways of the lathe. These corners will form the three points of the three sided bowl.
Make sense?