Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Brass buttons

Posts

Brass buttons

#1

Brass buttons

John Lucas

I haven't done much turning in the last week. I've been working on other projects for friends. I did turn these Brass buttons as replacements for 2 missing one on a friends solid brass table. They are duplicates of the one on the top right. The one on the top left was a boo boo. I drilled the hole for the tap using standard twist drill and apparently the center point was a few thousandths too deep. Just like turning through the bottom of a bowl. I drilled then next buttons using a flat bottom milling cutter. I also made the hole a little shallower.

I drilled the hole and cut them off to thickness on the metal lathe. I turned the shapes on my woodlathe using a Thompson 1/2" Detail gouge. I find the detail gouges really great for turning metal because they are so stiff they don't chatter.


Re: Brass buttons

#2

Re: Brass buttons

Bob Macgregor

I like the fuzzy-focus, fish-eye "self portrait of a photographer".

Oh, the buttons are nice, too!

BOB