Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Ashe Hollow Form

Posts

Ashe Hollow Form

#1

Bob Moffett

Ashe  Hollow Form

Bob Moffett

I made this hollow form from ashe, burned it with a propane torch to bring out the grain, rubbed it down with a wire brush, dyed it black and then dyed it red. In bright light the red shows through like a tint. The hollow form is 10” tall, 6” wide at the widest point with a 2 3/4” foot and just over ½” thick at the thickest part of the spirals and just under ¼” thick in the grooves. It has 6 spirals and 3 rings around the top. The finial is maple, dyed black and then painted with India Ink and is 5” tall. C & C welcome.


Re: Ashe Hollow Form

#2

Mike Stafford

Re: Ashe  Hollow Form

Mike Stafford

Very rich looking and elegant, Bob. You are definitely becoming the master of this spiral carving art.

Re: Ashe Hollow Form

#3

Ellis Walentine

Very nice!

Ellis Walentine

I really like the proportions and shapes you've combined here, Bob, not to mention the techniques. It's hard to believe the HF is 6"dia. x 10" H. That's a lot of work, and wood.

How thick do you leave the walls so you can do all that carving?

Thanks for posting.

Ellis

Re: Ashe Hollow Form

#4

Don Leydens

Re: Ashe  Hollow Form

Don Leydens

Another beauty, Bob! Love the way the spirals go into the 3 rings. I think you picked ash because you love to sand so much! Great piece.

Re: Ashe Hollow Form

#5

Leo Cuellar

Re: Ashe  Hollow Form

Leo Cuellar

Great form & the finish has a lot of depth to it. Sweet work!

Re: Ashe Hollow Form

#6

Lovely!


Re: Ashe Hollow Form

#7

Bob Moffett

Re: Ashe  Hollow Form

Bob Moffett

Thanks Mike

Re: Ashe Hollow Form

#8

Bob Moffett

Re: Very nice!

Bob Moffett

Thanks Ellis, The sidewalls are a little over 1/2" thick and I carved down a little over 1/4" so it is about 1/4" thick at the thinnest point. I usually leave the walls between 1/2" and 3/4" thick depending on how deep I want to carve. I usually stop carving at 1/4" so I'm less likely to go through the side.

Re: Ashe Hollow Form

#9

great piece