Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

New Turner

Posts

New Turner

#1

New Turner

Bob in NE Ohio

Guys

I usually post on the Flat side of this site but I know that the folks here will have the answers I need.

I just cleand up an old Craftsman lathe (single tube for a rail). It is 40" between centers and runs great after the rust came off! My question is what is the best design for a stand and how tall should the stand be?

Any help would be greatly appreciaated.

Thanks

Bob

Re: New Turner

#2

Re: New Turner

Don in Central Illinois

The 'average' height for a lathe is to have the spindle height equal to the height of you elbow to the ground. Remember, this is average, your mileage pay vary.

Re: New Turner

#3

Lyle Jamieson

Re: New Turner

Lyle Jamieson

Make it solid and strong with cross bracing so it will not flex or wiggle, add a box under it for sand to add mass. The heavier the better. Use leveling feet if possible. A good stiff strong stand will let you get the most out of a starter lathe.

Re: New Turner

#4

Re: New Turner

John Lucas

Ditto what both have said. Especially a heavy stand. That lathe doesn't have a very slow, slow speed, so you'll want a heavy stand. I've seen several people add what's called a Jack shaft to the lathe. This is a second set of pulleys that allows you to get really slow speeds for turning bowls. You can probably find info on that by doing a google search. I just did a search using the words "wood lathe jack shaft" and found lots of info and pictures.

Re: New Turner

#5

Re: New Turner *LINK*

Fred Holder

Hello Bob,

I built my lathe stand about 14 years ago for a Nova 3000 using the basic plan in the Nova 3000 Operating manual. For the last ten years, it has had a Nova DVR mounted on it. It is bolted together and has stood up very well. I used 2"x6" boards throughout, but basically used the drawing in their manual from the Teknatool Web site. The drawing is currently on Page 8 of the Nova 3000 manual downloadable from Teknatool's web site, given below. I filled the box on the bottom with scrap steel that I had on hand from my blacksmithing days, but sand might be better, and perhaps cheaper.

If you can't access the web site to get the manual, send me an e-mail and I'll send you the drawing as a *.PDF file.


http://www.teknatool.com/products/lathes/3000/downloads/Nova3000manual.pdf