Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Don Orr mentioned "cutting pace" below

Posts

Don Orr mentioned "cutting pace" below

#1

Steven Antonucci

Don Orr mentioned "cutting pace" below

steven antonucci

I thought it bore mention in case the thread below wasn't revisited by some of the folks that might have missed it. "Cutting pace" is actually the same term I use, so Don's hit on another important topic.

When I describe the cutting pace, I use a few variables to explain what you are trying to accomplish. The pace of the cut is dictated by how large the shaving is AND how efficiently the gouge can clear it, the type of wood, the speed of the lathe, the dryness of the wood, and probably another 2 dozen things.

I usually demonstrate it on the inside of a bowl by starting at the rim to get bevel contact, and then proceeding to cut with three fingers loosely gripping the end of the gouge. The slightest amount of forward pressure produces a cut. Stopping the pressure means no cut.

The pace is to move the gouge through the arc to produce a shaving with the same width from top to center, which means that you need to slow down as you get closer to the center of the bowl. At any given time, any tool is only capable of moving at some pace that is dictated by the shape and sharpness. Moving faster than this pace produces a diminished result.

Another good topic...

Steve

Re: Don Orr mentioned "cutting pace" below

#2

Re: Don Orr mentioned "cutting pace" below

Don Orr

Right on Steve. As many teachers and demonstrators often tell us, we should not force the cut. By allowing the wood fibers to be cleanly cut by the sharp edge of the tool, the resulting surface is much smoother than one that has been forced to be ripped apart.

I also, when teaching or demonstrating basic bowl turning, show how to cut cleanly with total control by doing what I tell my viewers is a total show-off moment. I make a cut on the inside or outside with just a few fingers of one hand. I start the tool into the wood with both hands and then let go with my left and proceed to make a clean, controlled cut. With proper tool rest support, bevel support, gouge rotation (slightly open to about 45 deg.) sharpness,and PACE, you have complete control of the cut. When it all comes together correctly, people are amazed at how much control you really do have. Disrupt any of those variables and things get much less controlable very quickly.

Thanks for opening up another good topic Steve.