Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Willow

Posts

Willow

#1

Dan Jechura

Willow

Dan Jechura

Have any of you turned willow? For cutting up a downed limb a lady let me cut off a Burl off a large trunk ( the tree is going to be cut down later) and I am wondering what I got myself into.

Dan J.

Re: Willow

#2

Dale Jablonski

Re: Willow

Dale Jablonski

The willow I turned was very soft. Good luck.

Re: Willow

#3

Re: Willow

Gary in Zirconia,NC

The willow burl I turned was very soft, fuzzy, and didn't have much character for a burl.

Re: Willow

#4

Re: Willow

John Lucas

I have turned some. I didn't like it. It's very hard to turn tearout free.

Re: Willow

#5

Re: Willow

Bob Bosworth

I have gotten pieces with spectacular coloration out of pussy willow. I have gotten pieces with very unique natural edge and modest grain variation in weeping willow. I have turned some very nice hollow forms with natural windows and a wide variety of color around the piece in Mountain Willow. Some of my best sales have been pieces from this genus. Go for it! bos

Re: Willow

#6

Steven Antonucci

Hard to turn tearout free?  More like impossible


Re: Willow

#7

Mike Stafford

Re: Willow

Mike Stafford

I have turned it once or twice but will not waste my time on it again. Lots of tearout and fuzziness requiring lots of sanding.

Best relegated to the burn pile in my opinion.

Re: Willow

#8

Re: Willow *LINK*

Doc Green

Hey Dan, I've turned a lot of willow, much of it punky. It can be challenging, but I like the end result - the pieces are surprisingly light and often have dramatic figure from spalting, which it does quickly.

It's almost impossible to get a clean surface while the wood is either green or wet, as it is very stringy and prone to tearout. However, it will dry quickly when roughed out.

Willow requires a lot of consideration just to get a clean cut. It's not your ordinary wood; it's almost a different material. A benefit of working with it is that it gives practice in striving for a clean cut, and the techniques you learn can then be applied to woods that are more "normal."

Many turners won't touch it. Some say it's only fit for the burn pile, and some go farther to say that it's not even fit to burn.

I have three articles on my website addressed to "Working Spalted and Degraded Wood" that you may find helpful:

http://www.docgreenwoodturner.com/spalted1.html

Good luck. If you try it, don't give up too quickly, even it if seems like trying to turn a sock.


Working Degraded Wood