HSS Drill Blanks
Tony - Memphis
A few years ago, I made a small coving tool following an article by David Reid. This weekend, I made a pencil using the Perfectcollection drill and mandrel. I used my cove tool to create some small grooves and figured out a smaller cove tool (diameter) would work better. I don't know where I bought my HSS for the tool I made (its about 3/32). I hit the typical sites, but they sell minimum quantities of 10 in the small diameters! Any good sources out there?
I considered just using the non working end of a drill bit, but read that they were too soft. BUt I'm wondering if they would be hard enough to cut the occaisional cove with? I may have very well used one for my current tool. I just can't remember and can't find an order or spare parts.
The tool works great, btw.
The Perfectcollection bit and mandrel worked pretty well. I had a hard time with the bit though. It didn't seem to want to cut through a maple pen blank I was using. I got through it, but it was ugly. I may need to slow it down. I did clean out a lot. He suggests boring with a 17/64" bit before to save the life of the stepped bit. I will do that soon as I can get one.
Thanks,
Tony
Tony



