Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Vessel Support

Posts

Vessel Support

#1

Dick Hines

Vessel Support

Dick Hines

Has anyone seen or have the new vessel support system by Carter? I saw one last night at Woodcraft. It sure is an upgrade from my home made one. Now all I need is information form some one that has tried one. And of course the MONEY to pay for it.

Re: Vessel Support

#2

Re: Vessel Support

John Lucas

I agree it looks awfully sweet. I am(or at least was) going to build one. However I really like the fact that each support ring is fairly slim and won't block the light from the laser nearly as much as my current homemade one and even the one I'm thinking about building.

Of course the cost is a pretty major factor so would love to hear from someone who owns one.

Re: Vessel Support

#3

Re: Vessel Support

gtwilkins

I was just looking at the pictures on the sales brochure where it shows the support in the bowl steady configuration and the rollers are on the back side of the lathe bed.

I thought you needed the rollers on the workpiece on the front side where you are applying the tools or doesn't it matter.

Trevor

Re: Vessel Support

#4

Dick Hines

Re: Vessel Support

Dick Hines

The support can also be used as a bowl support.

Re: Vessel Support

#5

Re: Vessel Support

Fred Holder

If this is the unit that your are talking about, it does look good.


They sent me a news release and it is scheduled to publish in my November 2012 issue.

Re: Vessel Support

#6

Dick Hines

Re: Vessel Support

Dick Hines

I saw one at Woodcraft last night. Looks like I may need good sales at my fall shows. :D

Re: Vessel Support

#7

Re: Vessel Support  *LINK*


Carter Steady Rest

Re: Vessel Support

#8

Re: Vessel Support

John Smith

I do not own one, but I have turned with one. The rest is very versatile. The wheels can be positioned almost anywhere you want them around the the ring. You can also add more wheels if you want. In bowl rest mode you can position the wheels on the front side if you want. That is where i would put them.

Another advantage is you can take a section out to install it. So after turning the outside of your vessel, you can install the steady while leaving the tailstock to support the end. eEasier to get everything centered.

The base is made with 2 moveable cleats for between the ways. I think it will fit the bed gap on any lathe. No need to buy an adapter or anything when you upgrade to your next lathe.

If I had not just built one, I would buy one of these in a heartbeat.

John

Re: Vessel Support

#9

Dick Hines

Re: Vessel Support

Dick Hines

I built one a couple of years. It works good but is very heavy. I made it so it is easy to install on my lathe and it works fine with my Jameison hollowing rig. I have not heard if the Jameison rig will work with the Carter system.