Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

new bowl from scrap.

Posts

new bowl from scrap.

#1

new bowl from scrap.

John Lucas

I just had to do something that took less than 60 hours to build. I've had this piece of wood that a friend gave me. It was shaped just about like this, wedge shaped and about 2" on the thick side and roughly 5" around. I decided it would make for a good challenge. It had lots of bugs that required thin CA and some really clean cutting. I used the new #2 Hunter Osprey to turn it. Very interesting tool but does cut very cleanly when used as a bevel rubbing tool.

I decided I'd just leave this wedge shaped although it sort of looks like I cut it this way on the bandsaw.

It was fun finishing a project in an hour or less.


Re: new bowl from scrap.

#2

Leo Cuellar

Re: new bowl from scrap.

Leo Cuellar

Pretty wood, John. That definitely puts a new slant on things, I like it!

Re: new bowl from scrap.

#3

Mike Stafford

Re: new bowl from scrap.

Mike Stafford

Like that bowl a lot John. With all that spalting did you have to stabilize it a lot? Did you notice any difference in the way the Osprey cut when it encounterd CA stabilized areas?

Did you modify the bevel any on the Ospreys? I did modify the bevel on mine and found them much more like a gouge when I did. I think the Ospreys are by far the easiest tools Hunter Tools makes with almost no learning curve since they mimic a gouge.

I like them on both end grain and long grain work. The sharp carbide cutters slice through end grain better than any tool I have used and can almost completely eliminate sanding. I have been using mine a lot lately on end grain walnut and red oak both of which responded well to the cutter.

Re: new bowl from scrap.

#4

Re: new bowl from scrap.

John Lucas

Mike I have not modified the bevel yet but think it needs it. I grind my gouges with a very short main bevel and think that I could use the Hunter carbide tip as the main bevel and take the rest of the steel below the bevel back a little. I will talk to Mike about this before I make a video. I think it will improve the tool and I guess you did also. I find that it cuts kind of sluggish and think it because the lower bevel is rubbing so there is simply too much steel rubbing the wood and creating friction.

Sweet cutting tool

Re: new bowl from scrap.

#5

Mike Stafford

Re: new bowl from scrap.

Mike Stafford

Yep, that is exactly what I did. I started using the tool with the original bevel and after a while decided to remove some of the heel. I kept doing this until I ended up with a reduced heel shape that I liked.

They do cut well. Obviously you cannot take as large a cut as with an open fluted gouge but the finish with the Osprey is the best.

Re: new bowl from scrap.

#6

Very Interesting Shape.  I like it, John!!!!


Re: new bowl from scrap.

#7

Man, you are "with it"...

GaryG in MD

This is a very "in" shape, John. I've seen them in restaurants.

Great idea! ...Gary

Re: new bowl from scrap.

#8

Don Leydens

This is too cool for school!

Don Leydens

I absolutely love this, John. The shape is intriguing and just right. Great piece!