Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Round, brown & rusty

Posts

Round, brown & rusty

#1

Leo Cuellar

Round, brown & rusty

Leo Cuellar

Haven't been on the lathe too much lately, but wanted to share one that didn't turn out too bad. This is Cherry about 6" in diameter. I used a round burner tip for texturing on the band. I had to dust off the carving tools and hack out the simulated rivets. I used Modern Masters Iron covered with Krylon clear coat which turned the rust bluish... fortunately shellac over that brought back some of the red tone. Then several coats of Watco semi-gloss lacquer.


I was finally able to track down some of the MM clear seal coat for their effects, so I'm going to do another one of these. Next one will have the band a little lower down the bowl with a full bead on each side of the band. This one looks a little "off"


As you are all aware, my camera isn't stellar, but I took these pictures in natural light outside the shop. Haven't had time to go look for something to diffuse the shop lighting.

Now I've got to run to the lumber yard & get a few 2 x 4's to build a shack for the compressor I'll be getting next week :)

Have fun everyone!!!

Re: Round, brown & rusty

#2

Don Leydens

Re: Round, brown & rusty

Don Leydens

Interesting rim treatment, Leo. Well done.