Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Rocking Chair Legs and Rockers

Posts

Rocking Chair Legs and Rockers

#1

Rocking Chair Legs and Rockers

Bill Lordan

Hello Everyone,

I have volunteered to repair an old rocking chair for a friend. The chair has sentimental value to the family. One of the rockers has snapped and 3 of the spindles are cracked. I have offered to make new spindles and rockers.

Turning the spindles and making the rockers does not worry me but I am concerned with the compound angles that I will need to deal with. I have no experience dealing with chairs. I do plan on drilling the angled holes in the chair legs while the blanks are still square and then use a dowel to fill the void during turning.

Can anyone offer any other suggestions that would improve my chances of completing this project correctly.

Your thoughts will be appreciated.

Bill Lordan

Auburn, NH

Re: Rocking Chair Legs and Rockers

#2

Re: Rocking Chair Legs and Rockers

Bernie Weishapl

Great post. I just happen to have a chair that is quite old that a close friend of mine brought in for repair also. One leg is cracked and broke while another has a crack running almost the full length. I can turn the spindles fine but hadn't figured out how to drill the holes for the stringers which are at a slight angle.

Re: Rocking Chair Legs and Rockers

#3

Re: Rocking Chair Legs and Rockers

Stuart Johnson

how to drill the holes for the stringers which are at a slight angle

Cut a piece of 2x4 at the correct angle and use it as a guide.

Re: Rocking Chair Legs and Rockers

#4

Ken Vaughan

Re: Rocking Chair Legs and Rockers

Ken Vaughan

Right on --

And instead of trying to measure the slope/angles use an sliding ajustable bevel to capture the angle and transfer it to the 2 by 4 drill guide.

http://www.leevalley.com/en/wood/page.aspx?p=32593&cat=1,42936,50298,43508

It is easier to transfer the angle than to measure and remeasure it.

Re: Rocking Chair Legs and Rockers

#5

Steven Antonucci

The answer to every chairmaking question *LINK*

Steven Antonucci

Peter is a buddy of mine, and an expert chair maker. If he hasn't covered it, it doesn't need to be covered.


Peter's Website