Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Fixing problems

Posts

Fixing problems

#1

Steven Antonucci

Fixing problems

Steven Antonucci

A good adage is that you can judge how good a turner is by how quickly he/she can fix a problem.

Yesterday, I had a tenon on a pretty large redwood burl vessel fail. In my mind's eye, I suspected that it might fail, and I was being careful in turning it,and the dang thing broke anyway.

I could have remounted it and turned a new tenon, but instead, here is what I did:

1. Using CA glue, I reattached the broken part of the tenon.

2. I cut a maple waste block and turned a tenon on it to fit the chuck.

3. I cut a recess in the face of the waste block to seat the old tenon.

4. I mixed up some epoxy.

5. Using the tailstock and a cone, I epoxied the old tenon within the new maple wasteblock.

6. Wait for epoxy to dry

Running about 95% true...

Steve

Re: Fixing problems

#2

Steven Antonucci

A picture of the fix

Steven Antonucci

In case it wasn't clear, the old tenon sits inside the maple one. Liberal use of the epoxy should hold until final turning is completed.


As previously mentioned, the goal was to get it remounted to spin concentrically. It's pretty close.

Steve

Re: Fixing problems

#3

Re: A picture of the fix

George Guadiane

Thanks for the post!

I have used similar methodology to get a piece back on the lathe. I just don't think to post it.

Yours is a great explanation and the photo makes it clear to me. Good Job!

Re: Fixing problems

#4

Re: A picture of the fix

Jim Breeden

Verrrry interesting - like it! Thanks Steven.