Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Gun lamp progress

Posts

Gun lamp progress

#1

Gun lamp progress

John Lucas

Last night I planed and carved the walnut "door" V's. Then I installed the door and clamped everything together. I made a jig to ride on the outside of the lamp so I could route out a rabbit in the body for a ring that I'm going to use to attach the lamp to the base. It will also serve as sort of door lock with pins at the bottom so you have to lift the door up and out to open it. The top locking ring will prevent the door from lifting up and out until it's removed.

It's so nice to have a lathe big enough to turn these rings. Sorry about the focus on the second photo. I hate auto focus. It apparently decided to shift just as I took the photo. Should have previewed the image and reshot it.

I've used a ton of hot glue for this project to temporarily hold all the various jigs and clamps. I've also used at least 4 or 5 different chucks or wasteblocks to hold everything.

Later tonight I'll mount the lamp to the base and work on the door fit. It's not bad as is but I think I can glue a thin strip on one edge and make it fit much more accurately with some careful planing. I'll know more once I turn it over and remove and replace the door a few times.




Re: Gun lamp progress

#2

Re: Gun lamp progress

mjonesrdg

You are pretty amazing!

Re: Gun lamp progress

#3

Re: Gun lamp progress

John Lucas

this is the door assembled after I cut the bottom ring apart with my Jewelers saw. The bottom fits almost perfect as you can see in these 2 photos. For some reason that I'll trouble shoot tonight the top doesn't. The joint is close enough that I could glue on some veneer and probably solve it. I'm wondering if some debri got in the upper rabbit and is holding it out. I didn't check it before this temporary assembly. I think once I sand the area around the joint it will be even harder to see. I raised the grain a little and got it kind of dirty while cleaning up the glue on the door paper joint.

I'm excited that's it's starting to come together. I may add one more ring toward the top. There's 291 parts in this thing so far. I might as well add another 32 + whatever the top will end up.




Re: Gun lamp progress

#4

Mike Stafford

Re: Gun lamp progress

Mike Stafford

John, this is going to be quite the heirloom when you finish. I would include a photo album documenting the entire construction with it as part of the gift which would make it more valuable to your son.

You are pretty amazing.

Re: Gun lamp progress

#5

George Taylor

At least compile them for "Shop Shots"


Re: Gun lamp progress

#6

Looking Great!