Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Platter

Posts

Platter

#1

Platter

Jim Breeden

How fast can one turn a WET Western Red Cedar into a platter, before it explodes on the lathe ? I turned the bottom fast as I could, sanded while it was making little "cricking" sounds, then saturated with oil to maybe slow down the process. Had to stop - Dinner is ready ! - wraped it in the wet shavings and stuck it in a plastic bag. Haven't yet had the nerve to open the bag today. And, of course, the pith is the center of the platter. :b

Re: Platter

#2

Mike Stafford

Re: Platter

Mike Stafford

Jim, am I understanding you correctly, you turned a platter from a cross section of log with the end grain and pith still in the center?

I don't believe that is recommended because of the fact the shrinking that will occur almost always results in cracking and splitting.

I have never turned a platter from a cross section/end grain wise through the log. I only turn platters with cross grain orientation.

If it works out for you I will learn something which is not unusual.

Re: Platter

#3

Re: Platter

John Veerkamp

I recently turned a 17" platter from Sycamore that was sliced from the end of a log. It was fairly wet, but not freshly cut. Turned to about 5/16 , it did not crack, but raised up a slight mound around the pith which was slightly off center. This was about 10 weeks ago and I still haven't decided whether to sand out the raised 4" dia section or leave it. I have also turned walnut platters end grain with success.

Re: Platter

#4

Mike Stafford

Re: Platter

Mike Stafford

Well, like I said, I learn something every day. I was told that one could not successfully turn an end grain blank for a platter without it splitting.

Thank you for setting me straight on that.

And Jim, as Roseanne Roseannadanna would have said, "Never mind!"

Re: Platter

#5

Re: Platter

Jim Breeden

I am just as surprised as you are Mike - it worked ! When it gave all those little cricks while sanding i had my doubts. This thing was wet ! I saturated it with Watco oil, still can't figur where all the oil was going. So far everything is ok, still in the chuck on the lathe waiting for what ever to happen. Had to wet sand to get it smooth. I'll send pictures - IF - I ever figure out the instructions Ellis sent out. :| Am not a computor person. :\

Re: Platter

#6

Don Leydens

Re: Platter

Don Leydens

Jim, I would love to see some photos of that when you get finished. I'm as surprised as Mike is, so please show us something we didn't know.

Re: Platter

#7

Re: Platter

Jim Breeden

Okee - Dokee :)