Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Turning A Platter

Posts

Turning A Platter

#1

Turning A Platter

Stuart Johnson

I think the first thing is to remember there is no one way and only that way to turn a platter.

My way.

1. Dry blank roughed out to approximate size.

2. Screw chuck in the top with a spacer if a thin blank. I don't use a glue block.

3. Outside shaped with a dovetailed recess in the bottom.

4. Inside turned and sanded.

5. Vacuum chuck used to final turn and sand the outside. I usually reduce the recess at this point.

6. Finished off the lathe.

This assumes I have been able to keep the bottom together. Many times I go back and forth between a dip and a dimple until the piece is destroyed. Doc Green talked about a scraper with a fine burr and I think that is the answer.

Re: Turning A Platter

#2

Re: Turning A Platter

John Lucas

Stuart I do the same sort of. I turn a recess for the chuck and then mark the center. After I turn the bottom with a recess for the chuck I reverse it of course and turn the front side. Then If I designed the bottom for the recess I'm done. If I want the recess gone I have 2 options.

One is to use a friction drive faceplate and mount the platter on that using the live tailcenter on the center mark to center everything up. The friction faceplate is just a large disc with an high friction type rubber on it. The pressure from the tailstock holds it in place. Then I can turn away the recess and reshape the bottom if necessary leaving just a small cone to carve off.

The other method is to use the vacuum chuck to hold the platter which of course gives you full access to the bottom.

On the rare occasions when I've done a sort of production run. I use the vacuum chuck to hold the blank. Turn the bottom with recess for chuck. Turn the front, reverse and use the vacuum chuck for the front.