Got the staves cut.
John Lucas
I decided to use modified version of Keith Newton's glue up jig. There is just a small amount of cut to many of the staves. I'm going to put dowels in the jig to allow me to glue up 2 at a time on the left and right sides. Then I'll move the dowels to new holes and glue up the pairs into 4. There is a small amount of cut to many of the staves. The jig will hold them together and I can put some more clamps across the staves to pull them into alignment. That should save a lot of work on the inside. I'm going to leave the inside faceted but I would like the joints to not have any big bumps if possible.
As you can see in the photo I could feasibly glue up half a ring at a time and since I'm going to turn the outside the cupped boards really wouldn't matter but I'm going to see if I can correct that. I cut 10 extra staves so I could cull any that moved or had bad chip out from my jointer. It took almost 3 hours to cut all the boards to length and then miter both sides. I was really tired of clamping and unclamping boards from the miter jig but it worked perfectly.
I'm hoping by the end of the day to have the glue up done. While the glue is setting on all the joints I'll work on the 2 floating walnut rings. I have the 2 rings for the bottom glued up and will flatten them and glue them together today also. Boy is is nice having 8 hours a day to work. This project would have taken me 2 months when I was working. 




