Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Box Elder

Posts

Box Elder

#1

Box Elder

Mark Mandell - Gone Round In New Jersey

After I lost a vase to core rot, I was more careful to select the next victim. It had some of the same punk on one end but the other seemed quite solid, so I went for it yesterday. Got the piece shaped


and about all but 2" hollowed when I started hitting a bit of rot. Since I've got to switch to my long 24" boring bar for the KOBRA anyway


I dismounted the piece and mixed up some thinned epoxy that got poured into the bottom to soak in and harden the weak wood. I figure it'll take two applications to finish. Memsahib has it dibbed already.

Assuming, of course, my resin trick works. ;) :\

Re: Box Elder

#2

Re: Box Elder

John Lucas

Looks great Mark. I found that a product called System 3 Mirror coat is excellent for penetrating punky wood. It becomes very viscous as it cures and penetrated deeply. In fact it will run through the pores on Red Oak. The downside is it works so well it can sometime penetrate clear through the wood and leave a mark.

Re: Box Elder

#3

Wow, Talent and

Mark Mandell - Gone Round In New Jersey

Psychic too?

That's the exact stuff I use. Meant for bar-top coatings, it's thinner than regular resin. You can find a cheaper version called "Glaze Coat" in some of the big box stores. MirrorCoat is a bit thinner, thus better penetrating, but takes longer for a hard cure. Other option is several marine products like "Get Rot" or similar names. I've also tried Polyall 2000 but do not like the results. The epoxies will take a dye tint which can give a very cool composite.

Re: Box Elder

#4

Dale Jablonski

Re: Box Elder

Dale Jablonski

Beautiful piece. Hope your fix works.

Re: Box Elder

#5

So Far

Mark Mandell - Gone Round In New Jersey

So Good. Phase 1 application got me within 2" of the design base. The second application penetrated very well and should be fully set up and ready to turn tomorrow.

Re: Box Elder

#6

Re: So Far

Mark Mandell - Gone Round In New Jersey

Hollowing is done to design depth (13") and I got the piece off the lathe in one piece. :)

It'll need another treatment before I can finish the foot, but it's looking like Memsa'b will get her vase this time. :D