Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

A box for Mike

Posts

A box for Mike

#1

A box for Mike

John Lucas

Remember the ugly box I did. Here is an improvement. Sorry about the photo. I don't have a studio set up at home yet. This is taken on my kitchen stove. I have a window over the sink to my right and the door to my left. Not sure where the green shadow to the box left is coming from. Both lights are daylight so if anything is should have been blue. Oh well, you can see the box anyway. It's about 2 3/4" tall. I should shoot it from a slightly different angle so you can see the door is recesses and see the door knob better.

Re: A box for Mike

#2

Mike Stafford

Re: A box for Mike

Mike Stafford

Very whimsical, John. This would be a perfect box for the Beads of Courage program. A kid would love it. I know I do. Very cute!

Re: A box for Mike

#3

Re: A box for Mike

Jim Breeden

Gets mo' better each time.

Re: A box for Mike

#4

Re: A box for Mike

Mike foster

John, this is wonderful. Great concept and execution. Is it partly done with pyro for the siding?

Re: A box for Mike

#5

Re: A box for Mike

John Lucas

I probably should have tried pyro but what I did was cut the horizontal gooves on the lathe and the vertical grooves were cut my hand using a chip carving knife and my index head on the lathe. That was the hard part because the knife cuts were too thin so I had to go back over each cut by hand off the lathe with the knife at a very slight angle just like narrow chip carving.

Re: A box for Mike

#6

Nice salvage job John, and my first......

JamieDonaldson

..impression was of the 3rd little pig and the big bad wolf blowing on his brick house!