Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Lamp gun cabinet is moving along.

Posts

Lamp gun cabinet is moving along.

#1

Lamp gun cabinet is moving along.

John Lucas

I purchase a bunch of air dried rough cut lumber to start this project. Spent the last couple of days jointing, planing and rough cutting the stuff. Man that's work. No wonder I like turning green wood. Here's a shot of the maple staves that are aclimating to the shop in preparation for the compound miter cuts.

The walnut moved more as I was cutting it but since it's going to be used for segmented rings in very short pieces that didn't matter. Here is a shot of those after the first glue up. there will be 2 more segmented rings and top piece to build but I need to have the main body of the lamp done before I can measure and build the rest.




Re: Lamp gun cabinet is moving along.

#2

If I were you, I would

Keith Newton

stack it with stickers, then make a tent with a tarp, and a little space heater blowing under it for the weekend. AD will be at 12% MC, and it will be going down to 6 ~8% after it reaches EMC in its final location. That means open joints, and problems which will be coming back to bite you in the butt later. Stacked dead like that doesn't qualify for much of a treatment.

Re: Lamp gun cabinet is moving along.

#3

I Agree

Barbara Gill

There will not be uniform drying with a solid stack.

Re: Lamp gun cabinet is moving along.

#4

Agree and not agree

mjonesrdg

Agree with stickering...and with space between the boards for airflow as well. Air Dry to 12% can be done, but below that, Arizona maybe. 6% is kiln dry...before it comes back up to EMC. Infinitesimally small movement across the grain after glue-up, and maybe 1% along the length of the staves. Well sealed and finished, should be no problem for an interior piece.

Mike, in Dry, Sunny, Hot, Redding, California

Re: Lamp gun cabinet is moving along.

#5

Re: Agree and not agree

bill Crommett

That stack of boards is a little large for building a tent, but if you do you can get a good sized bag of silica gel in the Walmart kitty litter department.

Re: Lamp gun cabinet is moving along.

#6

Re: Lamp gun cabinet is moving along.

John Lucas

Well I measured the MC and it came out at about 8%. I stickered them anyway. It's a no brainer to let them set. I'm not too concerned about the wood movement after it is assembled. The base will move very slightly differently than maple column but it will easy to assemble it so they can move separately.