Re: I have been in the shop---But
Lloyd in Mississauga
Depending on the turning being done, there seems to be a couple of key camera locations.
With a face plate piece, if the camera can be slightly in front of the piece (towards the audience) and above it towards the tail stock end, so that you can see the flute action it works well. One of the problems can be though that the auto focus on the camera does not click and you fight with that.
The other location would be an "over the shoulder" sort of view for spindle and outside of a faceplate work. Once again, likely more towards the tail stock end than right over the shoulder so that you do not have the turner blocking the shot.
With this type of boom, placed off the end of the lathe, but reaching in over top, the side ways swing would allow for the front or back shots and your pivoting platform aids in that camera position.
Have you looked at putting a pulley under the platform and back to the boom base linked with cables so that you can position the camera on the platform looking straight ahead, and then as you swing the boom side to side, the cables turns the camera with the boom so that you can keep the camera on the turning without needed to manually move it. As the boom swings, the camera platform would twist to keep the camera pointing at the same general location. Then the cameraperson would only need to worry about the up and down of the shot. You could rig a similar system for up and down motion of the platform as well. Add a couple of fine geared cranks to the support post for the cameraperson to move the boom in its too motions.
You'd need a way to initially zero it out, and then lock it in so that you have some adjustment depending on the piece being turned. Add in a remote zoom to the camera and viola.
Lloyd