Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Robust Tool Rest Question

Posts

Robust Tool Rest Question

#1

Robust Tool Rest Question

jake Niedling

I am planning to buy a Robust tool rest and I see they have two styles ( standard profile and a low profile ). Which one do you like? I was thinking of getting the low profile. Appreciate your comments.

Re: Robust Tool Rest Question

#2

Re: Robust Tool Rest Question

charlie belden

You didn't mention the swing capacity of your lathe or the size of the biggest stuff you turn or are thinking about turning.

I've got a JET Mini VS with a nominatl 10" swing so I got the low profile. Were I on a Stubby, Robust or maybe a VB36 . . .

Re: Robust Tool Rest Question

#3

Re: Robust Tool Rest Question

Roger Chandler

I have the low profile in a six inch rest....really like it a lot, as it allows me to get in close, and when I do a finial, I can reach my index finger of the left hand behind the finial for support on delicate cuts. I can use it well in spindle work and to get behind the form next to the chuck and headstock without having to worry about busting my knuckles.

Your mileage may vary.......

Re: Robust Tool Rest Question

#4

Re: Robust Tool Rest Question

Dave Paine

I have a 16in swing on my lathe. I purchased the standard profile.

I presently have 3 Robust tool rests, different lengths, so I could be considered biased. :)

Re: Robust Tool Rest Question

#5

Re: Robust Tool Rest Question

John Lucas

Jake I bought the low profile because I often reach around the rest to hold thin spindles. I find it plenty sturdy.

Re: Robust Tool Rest Question

#6

Re: Robust Tool Rest Question

ihmserv

I have the 12" standard robust, for bowls and larger turnings.

I have the 6" low profile for finials, pens. and small spindles.

both are used on a pm3520b

IAN

Re: Robust Tool Rest Question

#7

Thanks for the input...........

jake Niedling

I was planning on the 6" low profile mainly for the christmas ornaments and finials I do. It is for my PM3520A lathe. Thanks for the input.