Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Vacuum Pump Question

Posts

Vacuum Pump Question

#1

Vacuum Pump Question

dick gerard

Just how warm/hot should a Gast vacuum pump housing get? Mine was a retirement gift from my wife back in dec. 04. At times, it runs for the better part of an hour. I have noticed that the housing is warmn (I'd estimate around 90-100 degrees F.) Is this normal? Not looking for trouble, just curious.

Re: Vacuum Pump Question

#2

Re: Vacuum Pump Question

Chuck Engstrom

Hi Dick -- I'm inclined to think that anything you can still hold your hand on without discomfort is probably OK, though I don't have specific experience with Gast vacuum pumps.

Best--

Chuck

Re: Vacuum Pump Question

#3

Re: Vacuum Pump Question

Scott Crumpton

Here are a couple numbers that may help you decide how hot is too hot.

A NEMA insulation temperature tolerance class A (the lowest rated class) motor is rated to operate at up to about 220 deg F. I don't know the rating of the Gast motors. Import motors are probably not as good.

Anything over 120 deg F can get painful quickly if you're sensitive. 130 and up can quickly result in burns if the heat transfer rate is good, like with damp hands.

So yes, if you can keep your hand on it it's ok is correct and leaves a good margin for error.

Re: Vacuum Pump Question

#4

Re: Vacuum Pump Question

Bill Turpin in WNC mountains

Many motors are rated at 40°C rise above ambient. That is 104°F. So if your shop is 80°, then a motor temp of 184° is OK. Look on the nameplate, usually found there.

Re: Vacuum Pump Question

#5

Re: Vacuum Pump Question

John Lucas

Dick Mine is an older unit I got from the Flea mkt. It runs quite hot. Not too hot to touch but you wouldn't want to leave your hand there long. I keep wondering if it has a thermal cutout but so far it's never shut off. I am planning to build a cabinet for it to sit in under my lathe and I'm going to mount a cooling fan in the cabinet just in case.

Re: Vacuum Pump Question

#6

Harry Robinette

Re: Vacuum Pump Question

Harry Robinette

Dick

I put a hose on the exhaust port on mine and direct the air back over the unit. Mine now runs cooler.

Hope this helps.

Re: Vacuum Pump Question

#7

Re: Vacuum Pump Question

Dave Paine

I have an oil lubricated Gast 522, if I run mine for a long time, for me perhaps 20 mins, it gets warm like yours.

I like the idea of the other person to pipe the exhaust back over the unit. I will give this a try.

I feel if it is not too hot to touch, it should not be a problem.

Re: Vacuum Pump Question

#8

Re: Vacuum Pump Question

Doug Turner

Dick, I used the same Gast motors on air samplers for over 45 years and we ran some 24 hrs/day, 365 days straight without incident in very dusty atmospheres. Then changed the bearings, carbon vanes & filters and put them back into continuous service. They lasted several years under this service conditions.

They do run warm, but I have never seen one get hot enough to do damage unless the bearings seize. I use a Gast on my vacuum chuck and it works like a champ.

Doug Turner

Re: Vacuum Pump Question

#9

Re: Vacuum Pump Question

dick gerard

Thanks everybody! I knew I could count on thw Woodies!