Batting 300 GOOD, Two Out of Five - Not So Good
charlie belden
After three months without turning anything I thought I'd go back to basics - between centers turning - with a skew. Turn five bowl profiles on a stick, leaving a tenon & some room for parting off. Cut them off and then do some scaled down bowl turning into end grain.
First mini bowl - got careless and switch the lathe to reverse - at 2800 RPMS - and the chuck spun off - towards the back of the lathe - thankfully. Batting O for 1.
Next one - turned through the bottom. 0 for 2.
Turned through the bottom of the next one. Batting 0 for 3.
Managed to not screw up on the last two.
These are all about the diameter of a half dollar.


Why is batting 400 great - in baseball - and terrible for turnings?




