I want to make some artistic pen holders -- turned forms that will sit on a desk holding a pen artfully.
The problem is that if I just drill a conical hole for the tip (or more) of the pen to fit into, it will scratch the pen. I'd like to have some kind of soft material in there to cushion it.
Nothing simple comes immediately to mind. Have any of you already solved this problem?
....I doubt flocking would hold-up to repeated insertion of the pen tip.
If I were making this, I would turn a sleeve out of UHMW plastic that could be sunken within a turned wooden base support. Other non-marring plastics might also be considered (nylon, delrin, etc.)
Just a thought...... (...hey, give me credit - they only come along once in a while!)
Gary: I've done several desk pens. For each one, I simply used the cap hardware, inserted into the size and shape of the base that I wanted. The pen itself is made to fit into the cap hardware from the get go, so the pen is well supported. If you don't want the pen to thread into the base (I don't like that approach.), it's simple to drill out the threaded portion of the "cap".