Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Drum Sander

Posts

Drum Sander

#1

Drum Sander

Lewis Dodd

I am looking at a Grizzly 1066 drum sander,

what negatives are there other than being an import?

Re: Drum Sander

#2

Re: Drum Sander

darrin hill

you can make your own for about $200...

Re: Drum Sander

#3

Re: Drum Sander

Lewis Dodd

Well Darin, you certainly got my attention! Anxious to hear more! You getting pretty wet over there in Aggie Land?

Re: Drum Sander

#4

Re: Drum Sander

John Lucas

Lewis I built a simple one that was a Drum (2x4's glued and turned) driven by my lathe with sandpaper glued to it. Then I built a sort of tilt top table to sit on the bed of the lathe. The tilt was my height adjustment. I simply had wedge that a screw pushed in and out to raise and lower one side of the table.

It worked. It was a pain in the but to push the segmented rings under it. By the time you had 20 or so rings flat on both sides your fingers were sore. I always thought I would build a motorized platen to feed the pieces through but never did. Now I have a Performax sander that I got used. It is way nicer but takes up a huge amount of space in my shop.

Re: Drum Sander

#5

Re: Drum Sander

darrin hill

we griped all last year about lack of rain and now its flooding every other week...

I can get plans for one.. I didint build it, but one of our local woodturners made me one. If you're not in a hurry, i can introduce you to him if you are going to swat... he could probably tell you how to make it..

or i could give you his email...

d

Re: Drum Sander

#6

Re: Drum Sander

Doug

Hi Lewis,

See this link

www.aawforum.org/vbforum/showthread.php?t=9508

for some ideas.

Doug

Re: Drum Sander

#7

Re: Drum Sander

RCH

Search for thickness sanders on the web. Lots of plans. Luthiers build them up to 24" wide. I built one using an old furnace fan for power, for preparing ship modeling 'timber', that can handle up to a 12" width and >1 1/2" thickness. I used it for getting the faces parallel for a couple segmented pieces.