Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

PM3520 Spindle Lock Improvement

Posts

PM3520 Spindle Lock Improvement

#1

PM3520 Spindle Lock Improvement

Peter Hyde

Saw the slot idea over on the WWI forum. Easy mod, a few holes drilled in a line and clean up with a small file. Bent 1/4" cold rolled as a captured bolt.

Unlocked


Push the button and it's locked



Anyone know how to add this to the Mustard Monster site?

Re: PM3520 Spindle Lock Improvement

#2

Re: PM3520 Spindle Lock Improvement

Craig Daymon

Why make it so complex?

I marked the mid location of the button on the edges of the surrounding guard. Then I took the guard off, fitted it with a piece of wood to support the edges of the guard and drilled a hole through the side and passing through the other side.

Then I cut a piece of round steel bar stock, about the same diameter as the piece used in the photo. 3/8", and about 5/8" longer than the guard is wide. Grind down the ends so there are no sharp edges.

Put the piece in a small v-block and drill a 1/8" hole through the rod about 1/4" from an end. Run a piece of wire, maybe 3"-4", through the hole and tie it off. Put the guard back on the lathe and, before putting in the bottom screw twist the other end of the wire around the screw.

When you need to lock the spindle, Push the button in and slide in the pin. When you don't, just let it hang there.

That's what I did. Easier than cutting slots in the guard and bending the rod.

-Craig

Re: PM3520 Spindle Lock Improvement

#3

Re: PM3520 Spindle Lock Improvement

Peter Hyde

Hi Craig.

Yes I did it that way first. Means pushing in the button and holding it then use the other hand to slide the pin in. The new way is a 1 finger operation. Just push the button in and the bar drops down. Unlock it just push the bar up. Simple, quick and easy.

Re: PM3520 Spindle Lock Improvement

#5

#12 common nail

Jorge

My solution works as well and all it is: drop a #12 common nail in one of the holes around the spindle, rotate it until the nail drops in...

Why to complicate life??