Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Turning beads video *LINK*

Posts

Turning beads video *LINK*

#1

Turning beads video  *LINK*


http://www.youtube.com/watch?v=bjYehUsMdB4

Re: Turning beads video *LINK*

#2

Re: Turning beads video

Lloyd in Mississauga

Great video John.

What about adding in Al Stirt's method of turning a bead? I had watched it a couple of times and can not quite get the break down of the tool movements as he seems to start on one side, and cut up the side, over the top and then down the other side of the bead.

Lloyd

Re: Turning beads video *LINK*

#3

Re: Turning beads video

John Lucas

Do you mean Richard Raffen. Sounds like the same method. I tried it. I haven't played with it enough to be good at it. My beads are different sizes and shapes when I do that. I know it's faster and maybe I would get it down with practice but for now I prefer the uniformity of the ones I do now.

When I do long sets of beads like on my Mayan mirror or the entire outside of a bowl I do all of the right sides in one pass and then all of the left. It goes very fast this way and muscle memory after doing the first few really speeds things up.

I don't do the V cuts most of the time now because I can really twist the side of the spindle gouge into to the cut. I don't usually teach that method because it takes lots of practice.

Re: Turning beads video *LINK*

#4

Mike Stafford

Re: Turning beads video

Mike Stafford

I agree it does sound like the method that Richard Raffan uses.

It takes a little practice and a sharp tool but once you get the hang of it you can turn a lot of beads in a hurry.

Re: Turning beads video *LINK*

#5

Re: Turning beads video

DaveL

John:

Would you consider doing a video on captured rings? I have been turning for a while now and it gives me fits turning a clean ring. thanks.

Re: Turning beads video *LINK*

#6

I'll try to get one done some day soon


Re: Turning beads video *LINK*

#7

Re: Turning beads video

Galen Vetterick

Thanks John for another fine video demonstration. Also shows you do not need expensive tools to cut beads, just experience!

It had me fooled for a minute as the alternating wood color, lathe speed and frame rate I was viewing made the spindle look like it was turning in reverse.

Re: Turning beads video *LINK*

#8

Re: Turning beads video

john lucas

Yea that didn't show up on the camera but when I saw it as I downloaded I was glad I didn't slow the lathe down a hair or it would have looked like it was standing still.

Re: Turning beads video *LINK*

#9

Another excellent job John!