Adjustable lathe height-hope the link works *LINK*
http://www.youtube.com/watch?v=E-2Zu5ghlE0&feature=player_embedded
Adjustable lathe height-hope the link works *LINK*
Posts
Re: Adjustable lathe height-hope the link works *LINK*
#2
Re: Adjustable lathe height-hope the link works
Rob Wallace
Interesting.
Is this one of those automatic TV storage devices for sinking one's television into its cabinet through the top? These hardware systems are pretty pricey if I recall....
I guess it probably would be OK for pens, tops, small spindles, etc. but I would be concerned with stability and vibration for tuning anything with some diameter.
Might take more than 30 seconds to show how it behaves under these conditions...
Rob
Re: Adjustable lathe height-hope the link works *LINK*
#3Re: It is the base from a drafting table
Steve Criscenzo
We have several in the office but with more use of CADD they routinely get tossed. It is pretty sturdy but I would not trust it for anything off balance.
Re: Adjustable lathe height-hope the link works *LINK*
#4
Re: It is the base from a drafting table
Brad Vietje
Cool Idea...
Would be nice to mount that embedded in the floor so the floor surface covers the "H" shaped legs, and allows the operator to get close without leaning over so much. Great concept -- if not stable enough, are there other off-the-shelf mechanisms that would work better?
Another option would be a beefier platform with the lathe out to one side, and maybe a tool rack in the other direction. Could be very handy for seated turning, wheel chairs, etc...
Safe spinning,
Brad Vietje
Newbury, VT



