Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Turning green spindles

Posts

Turning green spindles

#1

Jack Guzman from Maine

Turning green spindles

Jack Guzman from Maine

I turned legs and stretchers for a Windsor chair out of green red maple that I rived from the log. I wrapped the lower vase of the legs where the stretcher is mortised into the legs with foil and put them in a kiln for a few days. When I chucked the legs into the lathe two of them were out of true. Very wobbly in the center. All I need do is size the upper taper to fit the chair seat mortise so the wobble didn't hurt much,but one of the legs is so out of round it can't be turned. Is this because of the still wet vase or is warping normal during drying?---Jack

Re: Turning green spindles

#2

Re: Turning green spindles

John Lucas

Jack warping is normal but it depends on where you get it from the log. I cut my chair legs from the outer area as far from the pith as I can. They seem to warp less. I don't make a lot of these, mostly stools and I usually let the wood season a little before I turn the legs for the stools. It's rarely fresh from the log. Others might have a different opinion but this is what works for me.

Re: Turning green spindles

#3

Re: Turning green spindles

Jorge

Jack,

Green wood moves a lot, specially if harvested in spring and summer, due to more moisture content. Stress when growing also makes for movement. When you are doing the riving, stick to the quarter sawn area, those move a lot less, and the areas 90 degrees from quarter sawn, is where most movement happens.

Re: Turning green spindles

#4

Jack Guzman from Maine

Re: Turning green spindles

Jack Guzman from Maine

I think my problem is poor wood selection. My usual supplier is out of logs at the moment . Being impatient,I decided to try a piece gotten from a relative locally. The trunk was fairly small and has a large branch coming off it right above the piece I used. It looked straight enough but there are probably stresses in the wood causing it to warp when drying. I'll just wait a bit and get a better log for this chair.---Thanks---Jack