Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Problem with drilling using my Jet 1642

Posts

Problem with drilling using my Jet 1642

#1

Problem with drilling using my Jet 1642

Starry Chan

I setup the lathe to drill a 1.5" recess in a round disc using a Forstner bit. As soon as I cranked the quill to start drilling, the disc grabbed the bit and pushed the tail stock backward. I tried different bits and I encountered the same problem. I tested the bits on the drill press and they are sharp. The tail stock was clamped as tight as I could. If I used the banjo to block the tail stock from moving, the headstock would move.

This is not the first time I used the lathe for drilling. I never have never encountered this problem. What did I do wrong?

Starry

Re: Problem with drilling using my Jet 1642

#2

Rotation of the stock in the right direction?


Re: Problem with drilling using my Jet 1642

#3

Re: Rotation of the stock in the right direction?

Starry Chan

Yes.

Re: Problem with drilling using my Jet 1642

#4

Re: Problem with drilling using my Jet 1642

Dale Miner

Is the quill spinning in the tailstock housing? The 1642 uses the lock lever to also stop the quill from spinning. An extra turn to loosen the lock is just about enough to let the screw disengage the keyway in the quill and allow the quill to spin.

Re: Problem with drilling using my Jet 1642

#5

Re: Problem with drilling using my Jet 1642

Starry Chan

Dale,

This is a great tip. I found my problem. The quill rotated slightly so that the lock level no longer engaged in the groove. This allowed the quill to spin. I reposition the quill and the problem went away.

A big thank you.

Starry