Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Hickory Burl Platter

Posts

Hickory Burl Platter

#1

Hickory Burl Platter

Dale Bright

This tray is from a piece of Hickory Burl a friend gave me, last spring. It had a lot of inclusions and a lot of rot. I intended to rough turn it and return it to the lathe after drying. When I took it out of the chuck and started cleaning the dust and some rot out, the tenon area simply fell apart. I decided to put into a large paper bag for drying for a few months.

This piece moved and warped a lot, as wet Hickory does, but I manged to jam chuck it for a little bottom clean up and then a lot of sanding, off the lathe.

The finish is just Walnut Oil.

I will post a reply with addition photos.

Size: 13" X 10" X 3"

Comments and critique are most welcome, thanks for looking.


Re: Hickory Burl Platter

#2

Ellis Walentine

Unique!

Ellis Walentine

You have brought in some interesting concepts here, with the curved-bark-on-slab aesthetic and the layered base. It looks like the whole arrangement is all connected, so I'm assuming these are not discrete elements assembled at the end. It's hard to see how much figure is in the wood, but I'll bet it shimmers.

Ellis

Re: Hickory Burl Platter

#3

Re: Unique!

Dale Bright'

Yes, Ellis, that is all one piece.

Re: Hickory Burl Platter

#4

That was an ugly burl to begin with,...

JamieDonaldson

..and you salvaged it in a way I would not have considered possible! ;)