Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Tap and die

Posts

Tap and die

#1

Dick Hines

Tap and die

dick hines

I am making some tool handles from aluminum rod. Need to know what size drill bit I need for a 1/4'x20 allan screw.

I have looked at the charts but it looks all Greek to me.

Re: Tap and die

#2

Re: Tap and die

Carol

#7

Re: Tap and die

#3

Re: Tap and die

Dick Coers

#7 is the recommended size which is .201"

Close in fractional size is 13/64" which is .203"

Re: Tap and die

#4

Re: Tap and die

Roger

Dick,

I sometimes drill a "practice" hole or two in some scrap to test sizes before drilling the hole in the piece I'm working on.

Re: Tap and die

#5

Lyle Jamieson

Re: Tap and die

Lyle Jamieson

Dick and Carol are correct. It is strange that the threads have a different scale for the drills needed. They go by numbers not fractions, in inches. You can find number drills in the old fashond hardwares, like Ace hardware. I would guess that it would be rare to find them in a big box store.

Re: Tap and die

#6

Re: Tap and die

Carol

Actually, places like Ace sell the bit and the tap packaged together. What's not to like? :)

A tip. I use a single flute countersink and drill a slight chamfer on the hole. Really helps get the tap started correctly and does away with the 'mushroom.'

Re: Tap and die

#7

Mike Hunter

Re: Tap and die

Mike Hunter

Dick ... why don't you go with 5/16-18. The allen wrench is the same as most chuck jaw screws and this T-handle wrench is generally handy.

Re: Tap and die

#8

Re: Tap and die

Roy

That will take a F drill bit.

Re: Tap and die

#9

Re: Tap and die

Bruce Smith

Most taps are marked with the required drill size right on the side below the pitch & size. Like Lyle

says they are usually number size but some have letter size.

Re: Tap and die

#10

Re: Tap and die

jim 9 miles

Noticed over weekend that Lowe's had taps & drill bits packaged together.

Re: Tap and die

#11

Dick Hines

Re: Tap and die

dick hines

Thank's for all the info. As far as the taps being marked with the drill size. the set I have is a CHEAP one I have had for years.

I am off to the tool store for a new set.

Re: Tap and die

#12

Re: Tap and die

Coyne

Where else can one ask a question and get that much helpful information and friendly advice?

Re: Tap and die

#13

Dick Hines

Re: Tap and die

dick hines

The only place I know of the kayak fishing page I go to. Ask a question and they come form everywhere just like Wooid Central.

We are lucky that Ellis has this sight.

Thank's Ellis.

Re: Tap and die

#14

Re: Tap and die

Bill White

Aluminum? I haven't thought of that.

Bill