I have made a few flutes here in the past few months, having a lathe at the ready, trying to figure out a way to hold the flute blank to be turned and tapered. mine now have a approx. 3/4 opening on 1 end and a 5/16th or so on the other, how could i hold that on the lathe, tried a chuck with a dowel pushed in, but really out of balance. Any suggestions appreciated. Dennis
..openings on the outsides, not the inside to avoid splitting. These can be held in the chuck jaws and centered in the tailstock, just don't crank up the quill too tight!
John K. Jordan who used to frequent this site turned a beautiful Native American flute a couple of years ago under the guidance of Billy Whitefox during our week at John C. Campbell. I watched him do it but I don't feel comfortable explaining the process he used. It was a thing of beauty when he finished. I have attached a couple of variations John turned. The magic wand flute out of bloodwood was magnificent.
Dennis...Ernie Showater from Midland Texas demo'ed these at SWAT 5 or 6 years ago with handouts and all, might call or contact him , best I remember they were 18 to 20 inches long.
Ernie is a personal friend of mine. E-mail me at jedwa33900@aol.com and I'll get you in touch with him. We are members of the Commanche Trail Woodturners in Midland, Texas, an AAW chapter.