Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

wipe on poly not drying

Posts

wipe on poly not drying

#1

wipe on poly not drying

john lucas

I've never had problems with this stuff before other than it going bad in the can. I made the first Genie bottle and coated it with one layer of the poly and then buffed it out the next day. On the second Genie bottle I decided to make it more glossy and put 2 layers on. The second layer was not dry at all on the next day. I checked it last night after getting back from my Knoxville Demo and it seemed dryer. It is dry on the yellow heart but not on the African Blackwood. I'll check it again tonight after I get back from Nashville. I seem to remember someone else having problems with blackwood and poly.

Re: wipe on poly not drying

#2

Re: wipe on poly not drying

Ralph Lindberg

I have had some issues with oils in the wood messing with drying. It might be the oils in the blackwood ????

Re: wipe on poly not drying

#3

Re: wipe on poly not drying

matt overton

I have had trouble with oily woods allowing finishes to dry. I am now wiping them with acetone before the initial coat and having much better luck.

Re: wipe on poly not drying

#4

Walt Bennett

Re: wipe on poly not drying

Walt Bennett

It's the wood. Wipe everything off with mineral spirits very thoroughly and try again. I've found I can get wipe on poly to cure on just about anything if I first clean off the oil with this really well.

Re: wipe on poly not drying

#5

Re: wipe on poly not drying

Ralph Watts

John,

Same problem here a couple of times. If all else fails, a couple of coats of shellac will allow any finish to be applied. BTW, I really like this series... Ralph

Re: wipe on poly not drying

#6

Ellis Walentine

Blackwood and varnish

Ellis Walentine

Blackwood, (Dalbergia melanoxylon) is a member of the Dalbergia genus along with all the true rosewoods. All these woods contain chemicals that inhibit varnish drying. Your best bet is to use lacquer instead, or apply a barrier coat of something like shellac prior to varnishing.

Ellis

Re: wipe on poly not drying

#7

Thanks everyone I'll work on it.


Re: wipe on poly not drying

#8

Mike Stafford

Ellis nailed it!

Mike Stafford

Varnish and rosewoods do not mix. I like to use a brush on lacquer thinned 50% steel wooled between coats if I use anything at all.

Most of the time I just finish with wax.