Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

3520B Banjo behaviour

Posts

3520B Banjo behaviour

#1

3520B Banjo behaviour

Peter Hyde

I've been doing coring using the bed extension in the low position and the Powermatic banjo and tool post extension. The banjo keeps loosening. It happens pretty fast the handle just moves up into the loose position. If I lock it down to the left it holds a lot longer but to the right it releases within a few minutes. Any ideas?

Tried all the normal stuff like cleaning and adjusting the clamping plate nut but the handle just won't stay locked down when tightened to the right.

Re: 3520B Banjo behaviour

#2

Re: 3520B Banjo behaviour

Nick Todd

Peter,

Try loosen the locking plate a litte. It will allow for a longer locking range and may hold better. If I losen the locking plate on my banjo any more the handle would rotate through. It also allows the banjo to slide more freely.

Nick

Re: 3520B Banjo behaviour

#3

I agree with Nick


Re: 3520B Banjo behaviour

#4

Re: 3520B Banjo behaviour

Peter Hyde

Thanks guys. I have already tried that and found that for some reason the handle locks in a different position on the left (8 o'clock) than the right (5 o'clock) When locked down on the left it stays locked for a longer time so that would suggest it needs to lock in a lower position say about 7 o'clock, but if I do that then locking to the right means the handle goes right through the lock position and does a full rotation. I'm wondering if the shaft is bent.

Re: 3520B Banjo behaviour

#5

Re: 3520B Banjo behaviour

john lucas

sounds like the shaft is either bent or rotated slightyly.

Re: 3520B Banjo behaviour

#6

Check to see if the bronze bushing......

JamieDonaldson

...that holds the shaft in the casting has been displaced. I've seen this happen occasionally on Powermatics. And clean any lubricants off the shaft as well.

Re: 3520B Banjo behaviour

#7

Re: Check to see if the bronze bushing......

Peter Hyde

Thanks guys. I might get time this weekend to pull it all apart and see what's going on. Suspect it is a bent shaft but the bushing sounds like it could be another culprit

Re: 3520B Banjo behaviour

#8

Re: 3520B Banjo behaviour

Peter Hyde

Pulled it all apart and found nothing! There is no bronze bushing in mine, just steel to cast iron. Checked the cam for straight and no problems. So all back together and it appears problem has gone but I'm still no wiser. Maybe got a gremlin from somewhere who wanted some fun. :)

Re: 3520B Banjo behaviour

#9

Re: 3520B Banjo behaviour

John Lucas

It could have simply been dirty and not worked as efficiently as it should have.