Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

segmented corian inlays or something,,

Posts

segmented corian inlays or something,,

#1

segmented corian inlays or something,,

darrin hill

i was going to see how to glue corian and wood together to make a ring for a segmented turning i want to do...

would tight bond work to hold corian, will it shave like the wood? do i need to pick an appropriately harder wood to match the corian ? I once put oak and cedar together to make a pendant to see how it would work, and i had a lot of oak left and lots less of the cedar after sanding... so how does it sand?

Re: segmented corian inlays or something,,

#2

Re: segmented corian inlays or something,,

Grant Wilkinson

Darrin: I've bonded Corian to wood in pens and in a couple of open segmented vases. I've had no luck at all using Titebond III with Corian. I love the glue and use it for wood to wood joints, but with plastic, I've not been successful. For Corian to wood, I've had perfect results using either gel/thick CA or rubberized CA. I only started using the rubberized with my last vase. It takes longer to set than even the gel, but it's supposed to be able to take a shock without breaking. I figured turning open segments constitutes a "shock", so I tried it. Nothing blew up, so I consider it a success. (Nothing blew up with the gel, either, though.)

As for good combinations, I'm sure you will get lots of input. In pens, I've joined it with several different hard woods. In vases, both of mine have been cherry.

Re: segmented corian inlays or something,,

#3

Re: segmented corian inlays or something,,

John Lucas

I've used epoxy for gluing corian and wood. It turns pretty much like wood. I always worry about wood movement problems because the Corian won't move and the wood will. for that reason I've kept my pieces short on those projects so the wood doesn't move much.

For segmented work rotating the rings so the corian is overlapped by wood will help the strength of the glue up.

I have inlayed corian into my mirrors. With that technique wood movement isn't as much of an issue and the strength of the bond isn't tested either.

Here is a quick grap shot of an ornament I made in 2003 using Corian and wood.