Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Finding the bottom of the bowl

Posts

Re: Finding the bottom of the bowl

#2

Re: Finding the bottom of the bowl *LINK*

Doc Green

Very clever, and quite simple to build!

The link below will take you to three other versions that require a bit more in the way of construction.


Doc's Website, Thickness gauges

Re: Finding the bottom of the bowl

#3

Re: Finding the bottom of the bowl

John Lucas

I don't have any trouble finding the bottom. I reverse the bowl and then just turn until I can see it. :)

Re: Finding the bottom of the bowl

#4

Re: Finding the bottom of the bowl

Hal Taylor

Very useful and clever idea. Thanks for sharing. Even though, I'll bet I can still make a funnel!

Re: Finding the bottom of the bowl

#5

Dick Hines

Re: Finding the bottom of the bowl

dick hines

Finding the bottom is easy. Not finding the bottom is the hard part. :D

Re: Finding the bottom of the bowl

#6

Re: Finding the bottom of the bowl*LINK*

Geoff Kelk

Here is a very quick and easy method that works very well for me...

www.woodlotharvest.com/Index/Measuring_base_Thickness.html

Re: Finding the bottom of the bowl

#7

Too easy!     (thanks!)


Re: Finding the bottom of the bowl

#8

Two or three more

Barry Irby

I put a piece of blue tape on the side of the ways under the chuck. Use a square to put a mark on the tape representing the face of the jaws. Turn the bowl to the point the rim is established and plumb that down to the tape. Then you can measure the total depth of the bowl, and then the depth of the bowl by using the straight edge across the rim. Then compare the interior depth of the bowl to the total depth and you can see the remaining thickness of the bottom.

Similar to one of the methods above, you can set the tailstock at the far end of the ways and cut a dowel to the length of distance between the face of the chuck jaws and some known fixed point on the the tailstock. I ignore the quill and use the front edge of he casting where the quill enters. That way I don't have to set the quill correctly each time. Then you turn the bowl and from time to time touch the dowel tot eh interior bottom of the bowl and compare the other end to the known spot on the tailstock. You could mark graduations on the dowel but I just eyeball it. (I like this method because it parks the tailstock back out of the way and does not require moving it.)

Another way I measure the bottom is to use a gauge I made that looks a lot like a giant pair of scissors. When I reverse chuck onto the Cole jaws, I can reach between them and measure the bottom thickness.

Re: Finding the bottom of the bowl

#9

I like it...

GaryG in MD

Very simple, quick, and to the point.

Thanks for the idea, Gary

Re: Finding the bottom of the bowl

#10

Re: Finding the bottom of the bowl

Randy Gleckler

Cool Idea, I will have to file that in memory to use. Thanks