Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

RIT Fabric Dye - How ?

Posts

RIT Fabric Dye - How ?

#1

RIT Fabric Dye - How ?

Bob Salvetti

Just back from the grocery with some RIT fabric dye. Been wanting to try out on some wood turnings and now I'm one step closer. Any suggestions on how to mix - how much? water? alcohol?

Any other cautions? etc., etc., etc.

What finishes before / after application?

Many thanks for sharing your experiences.

Bob in Georgia.

Re: RIT Fabric Dye - How ?

#2

From "Russ's Corner"....

mjonesrdg

From the menu at the top left of your WC screen, click "Articles" then "Russ's Corner"....

".... I have not had any success using Rit® or similar dyes made for cloth. These dyes are a heat-setting type and must be boiled into the material being dyed, and I have never found boiling to be a good technique for finishing wood."....

Lot's more good info there on dyes for wood.

Re: RIT Fabric Dye - How ?

#3

Re: From "Russ's Corner"....

Roger Chandler

I have used rit dye for turning........and had good results on maple. I used about a teaspoon of dye powder, mix in about a cup or so of denatured alcohol in a discarded plastic butter dish.........stir until most of the crystals in the powder are dissolved. The more times you coat a piece, the deeper the color becomes......

I painted my pieces with a foam brush..........one could also dip in the dye, if the piece is small, but brushing several coats will do the job.............wipe off the excess, and let dry, then finish with Wipe on poly or some other similar finish.

Re: RIT Fabric Dye - How ?

#4

Walt Bennett

Re: RIT Fabric Dye - How ?

Walt Bennett

I posted a caution about RIT on the AAW site as well. It isn't all that permanent if exposed to sunlight. This from my wife's direct experience with her hats. She uses two of the more professional dyes instead (also a bit more expensive) and doesn't have this problem. Any can be used with alcohol vs. water and then covered with a finish, but unless you're certain the piece won't be exposed to a lot of light (including fluorescent), you might want to use something better than RIT.

Re: RIT Fabric Dye - How ?

#5

Re: RIT Fabric Dye - How ?

Emmett Manley, Lakeland, TN

I've tried various means of coloring wood (dyes, paints, iron acetate solutions, etc.) but I am most pleased with the results provided by leather dyes from Tandy leather. Inexpensive, convenient, and very effective. I apply the dye to dry wood, allow to dry, lightly sand, and repeat dyeing. USMC black allows one to make ebony from almost any wood. Some of the red dyes also work well, and I assume other colors would be equally effective.

Re: RIT Fabric Dye - How ?

#6

Re: RIT Fabric Dye - How ?

kellyanderson72

I knew someone who was refinishing a sewing machine cabinet once and he used Kool-Aid to dye it. It turned out great. I haven't seen him for a while so I do not know how light fast it is.