Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

TAW symposium camera boom

Posts

TAW symposium camera boom

#1

TAW symposium camera boom

Jeff Brockett

Materials, instructions and photos for building the camera boom used at the TAW symposium. For questions send a PM.

Small quantities of 1/4", 1/2" and 3/4" plywood

Office chair with wheels-got free from a used office furniture supply store

1/2" thin wall electric conduit-10 ' section -some have a line up the side and it helps when drilling holes

3/4" thin wall electric conduit-same as above

1 ea 12" truss strap 1 1/4" wide-cut, drilled and bent into 2 U shaped brackets

1 ea 18" truss strap 1 1/2" wide-drilled and bent into moving handle

misc bolts, fender washers, nuts, fixture knobs and 1 handle - 3/16" and 1/4"

2 ea lag bolts about 3" long to connect 19" box and the other wood assembled section

Remove chair seat and throw it away

Cut plywood and make 19" high box, width and depth determined by the remaining base on the chair

Cut the plywood pieces, glue up and crown nail together-see drawing #1 for sequence- of the top section of assembly

Holes in side of largest plywood pieces are for pins if counter weight(see below) is not sufficient

Use lag bolts to join the top section to the box and box can be attached to chair with 1/4" carriage bolts/nuts

cut 1/2" thin wall conduit 70" long and use pipe bender to bend end about 1" off center - see drawing for hole drilling

cut 3/4" thin wall conduit 87" long and see drawing for hole drilling

12" truss strap- cut, bend and drill 2 U shaped brackets to be attached to the camera platform and then ends of conduit

18" truss strap-drill and bend as per drawing B - attach handle to top

will have to turn and drill round spacers, cut at an angle in handle assembly-see photos

You will need an approx. 8# weight as a counter weight on the short end of the 3/4" conduit- drill a hole and use a pin to keep in place









Re: TAW symposium camera boom

#2

Steven Antonucci

You gotta know that I would love this!


Re: TAW symposium camera boom

#3

Re: TAW symposium camera boom

Randy Gleckler

And with the Camera they used that had a zoom on a wire... This worked SOOOO well. Good job Jeff

Re: TAW symposium camera boom

#4

Re: TAW symposium camera boom

Jeff Brockett

Mike Zinser created this. We are working on some better drawings and Mike is going to add a manual swivel to the camera platform. Randy, you are correct in that the wired remote made this camera much easier for the operator to use. We tested the wireless remote and it was useless.

Re: TAW symposium camera boom

#5

Re: TAW symposium camera boom

john lucas

Jeff thanks for posting. I did get the photos from Mike but have been out of the office the entire morning.

Re: TAW symposium camera boom

#6

(Message Deleted by Poster)


Re: TAW symposium camera boom

#7

Which make & model camera?

Mike Brazeau

You mentioned a camera with a wired remote. What manufacturer and model was used?

Re: TAW symposium camera boom

#8

Re: Which make & model camera?

Jeff Brockett

The cameras were Sony camcorder model HDR-CX360 and the wired remote was Sony model RM-AV2. I found the wired remote on amazon.com for $33.00 each.

Re: TAW symposium camera boom

#9

Re: TAW symposium camera boom

Jeff Brockett

One more attempt to get a decent drawing that is readable.