How to turn Burls?
Adam Baum
All - I am attempting to turn my first burl bowl and have run into a significant roadblock. There was a slight crack/knot/whatever-it's-called on the outside when I first mounted it. As I roughed out the exterior, what was a small "defect" opened up quite a bit. It was as if there was a huge irregular shaped air pocket with jagged edges going deep into the burl. My background is furniture and boxes so I resorted to what I would do for them - tape up any and all openings and apply epoxy. What I was not expecting, or thinking about, was the amount of epoxy required. I've got more than 6ounces in this 6" diameter bowl. Depth is about 5". That seems like quite a bit to me.
Four questions:
1) Should I not complete the turning due to the amount of epoxy used?
2) Should I have completed the rough turning inside and out and then taped up all openings, applied epoxy, and then a final turning?
3) Should I have approached burl differently than regular wood?
4) If I should keep moving forward, what would be the best (ie..safe) way to proceed?
Adam







