Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Carbide Tools

Posts

Carbide Tools

#1

Carbide Tools

Tony - Memphis

I posted a week or two ago asking about carbide turning tools. I ended up buying Easy Wood Tools at Craft Supplies USA. They had a sale on and I ordered them unhandled, so it was a pretty good deal. I bought the mid sized tools - the rougher and the finish tool. I also ordered a 2" radius cutter (fits on the mid sized rouger). I made handles for them last week and got them glued in and tried them this weekend. Wow! I was very impressed. It will take some getting used to, but I am pretty happy so far. I just played around with a spindle (I'm a furniture builder). I think these will help me a great deal with my turning. I plan to get the detailer someday. Just thought I'd follow up in case anybody else is pndering a similar purchase. To qualify, I am not a turner. I build furniture with turned parts. I make a few things like pens and pepper mills now and then. Turning is still somehwat of a mystery to me. The things I have turned that turned out well I write off to being lucky! I turn on a Jet mini. Oh, I also tried them on a real ugly piece of acryolic I won in a local store drawing (UGLY!). They handled that pretty well too. I didn't get quite as smooth a surface, but I have never done great with acrylics anyway. I've only turned a few of those curcuit board pen kits.

Tony

Re: Carbide Tools

#2

Re: Carbide Tools

Fred Holder

Hello Tony,

There is quite a bit of controversy over the Carbide Tools. My first introduction to carbide tools was at the Desert Woodturning Roundup, when Mike Hunter was trying to introduce his tools. I purchased one of his 3/8 inch tools and later did a story on the tool. I was impressed with the cutting capability of the tools. I think that was six years ago.

A couple of years later, at the Desert Woodturning Roundup, I was introduced to the Easy Wood Tools. I was impressed with its ease of use and felt that for a beginning turner it would work very well. I've been turning since 1998 and can use virtually all of the woodturning tools on the market. For roughing a spindle, I immediately reach for the Easy Rougher because it puts less stress on my body as long as you have the tool level and cutting on the center of rotations height, it does a fantastic job.

These tools are not really scrapers as many experienced turners claim. They are cutting tools and on some woods produce nice shavings. Do they cut as clean as a good gouge or a skew chisel? The answer is no! If your do your complete turning with an Easy Wood Tool, it takes a coarser sandpaper to begin the sanding.

I did, to proved it could be done, turned a bowl completely from start to finish with the Easy Wood tools, I also have the Easy Wood Tool Finisher.

I wish they had been available in 1988 when I started turning.

Fred Holder