Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Angle grinder cutters

Posts

Angle grinder cutters

#1

Angle grinder cutters

john lucas

I had time to play with various angle grinder attachments for carving this weekend. clockwise from top left. Arbortec, Lancelot, 24 grit sandpaper, Holy Gallahad course, Kutzall medium, flap wheel from Lowes.

I place them in roughly aggressiveness order going clockwise from top left. The Arbortec and Lancelot are about the same as far as aggressive and dangerous. The rest are considerably less dangerous but of course not as aggressive.

You can cut grooves with the Arbortec and Lancelot. With the 24 grit and the think Holy Gallahad you can cut a somewhat widened groove. Groove cutting is the most dangerous technique. Use both hands and take light cuts and you'll be OK.

I have the medium Kutzall and it's not as aggressive as the Holy Gallahad but then the course Kutzall might be the same. The flapwheel from Lowes is inexpensive and does a decent job but clogs up and goes bad fairly quickly.

The 24 grit sandpaper is pretty effective, not any where near as dangerous as the Arborec and Lancelot, and is pretty inexpensive although you would have to do a long term test to see how the carbide cutters of the Arbortec hold up vs replacing sandpaper discs fairly often.

A really good way to go if your going to do a lot of carving is the mini Arbortec. It is much safer as far as controlling the cut and will reach into tighter places. It will still cut you badly so be careful and use both hands. It feels much much better from a control standpoint.


Re: Angle grinder cutters

#2

Steven Antonucci

More work for you...

steven antonucci

John-

I have most of the things you show, but I think it would be interesting to also show the the surface quality and how much wood each one can move in a single pass? Used properly, each has it's place...

Steve

Re: Angle grinder cutters

#3

Re: Angle grinder cutters

john lucas

Steve I just don't have time for that right now bit it also isn't really fair since I don't have equal "grits" for each type of cutter. I can say that that for the most part the more teeth it has the smoother and slower the cut, however quality of cut has a lot to do with how fast you move the cutter.

With any of these cutters you are going to have to clean up the work with some other cutter or sandpaper because these are designed for fairly fast removal of stock.

If you want fast removeal do what my friend Brad Sells does and put 2 or 3 cutters on one shaft. Brad has many since he does this for a living and some of the more fun ones are 2 Holy Gallahads back to back with a Lancelot inbetween. 2 of the smaller chain saw cutters spaced about 3/8" apart on one shaft. These remove lots of wood very rapidly. Brad swears by air grinders saying they are safer than electric.