Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Burn Barrel Resurection #5

Posts

Burn Barrel Resurection #5

#1

Burn Barrel Resurection #5

Dick Wilson


Well, I looked at a turning laying on my bench last week that went south on me and an idea came to mind. This was headed towards being a beautiful Curley Maple bowl. That was until I got a phone call and had to run down the street. I forgot to bag the turning on my lathe. It was late when I got home so back to the lathe tomorrow. Next day I remembered.......the bowl had a huge crack in the end grain. Off the lathe and tossed on the bench rather unceremoniously.After cutting, carving, sanding, and pyro this is what I ended up with. Base is Ambrosia Maple. "Bowl" is about 8" in diameter. Satin spray lacquer. Comments and critiques welcome.

PS - as some of you know I have been working on my photography. If interested you can see the original pic of this piece on the Photo Forum.

Re: Burn Barrel Resurection #5

#2

Re: Burn Barrel Resurection #5

Jim Breeden

WOW ! If only something I threw on the bench looked that good ! :)

Re: Burn Barrel Resurection #5

#3

Brad Vietje

Photo Forum?

Brad Vietje

Hmmm..., gotta look for that!

BV

Re: Burn Barrel Resurection #5

#4

Re: Photo Forum?

Dick Wilson

Brad, go to top left on messageboard and click photography

Re: Burn Barrel Resurection #5

#5

Re: Burn Barrel Resurection #5

Lewis Dodd

Very nice work, you carve the base also? Great Pyrography.

Re: Burn Barrel Resurection #5

#6

Re: Burn Barrel Resurection #5

Dick Wilson

Lewis, I removed the bark and used a Dremel flap sander to bring out the grain. Turned it round on the lathe.