Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Christmas Tree Wood - ideas?

Posts

Christmas Tree Wood - ideas?

#1

Christmas Tree Wood - ideas?

Sandor in Middletown, DE

So 1 year ago, I cut a 1' (~5"Dia) section from the trunk of our tree before hauling it to the yardwaste center to be turned into mulch. This was going to become an annual tradition wherein I was going to turn an ornament from the wood from the tree to keep the tree's spirit alive (my 7 year old daughter's idea).

OK, so I had this piece drying in the shed for 11 months and then went to make something of it. Even though it was left in the log form, the checking was not too bad. But it was a Big mess, sticky sap everywhere even though the wood was "dry". The wood had bad tearout and the knots were beating me up good. My tools were very sharp but I could not get a good finish.

Any suggestions as what to do with the 1' x 5" dia log presently sitting on my workbench to make it workable by December? Yeah, I'm going to try again.

Would an alcohol soak help with the sap? Should I just take up spirit carving?

I had it in mind that I would make some kind of icicle looking turning and burn the year into it.

Thanks,

Sandor

Re: Christmas Tree Wood - ideas?

#2

Re: Christmas Tree Wood - ideas?

Lewis Dodd

What kind of wood? Cedar is pretty notorious of what yu describe. Course fir and spruce (pine) have an overabundance of sap also. I might suggest a series of candle holders, Even tho it is taboo in wood turning I put small felt circles on mine to prevent the sap from seeping out of the endgrain onto the cabinentery. Been doing this for the last few years when we had a "live" tree

Re: Christmas Tree Wood - ideas?

#3

Brad Vietje

Ornaments

Brad Vietje

Most years, I cut about 6 - 8" from the bottom of the trunk, at the widest extent, and turn a few hollow ornament globes from it. We didn't have a tree last year, but we had a beauty this year, and I haven't cut the base off yet.

Balsam Fir is the most common Christmas tree around here, and while not a great turning wood, it's always fun to have an ornament from last year's tree (or the past several years) to hang on the new tree.

I think I'll revive that practice this year. I rough out the ornament globe while the wood is still green and sticky, then finish turn, sand and polish months later -- like next October, when I start thinking about Christmas coming again.

Safe spinning,

Brad Vietje

Newbury, VT