Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Turned dowel into a spline shaft.

Posts

Turned dowel into a spline shaft.

#1

Turned dowel into a spline shaft.

Lloyd James

I turned a shaft 1- 3/8 Dia., and I want to cut 12 splines along the length..

I made a fixture for making grooves with a trim router. The fixture sits and is center on

the lathe bed.

I am using a small Dunlop/Sears lathe that has 60 index holes in the belt pulley. There is a pointed pin that slides slides forward to lock the chuck.

I am having trouble with this set up. Sometimes the pin just slips out of the hole.

I have tried putting a clamp on the pin and part of the rear housing. This method

Has worked, but is kind of crude.

Has anyone ever made an index plate to go with their lathe?

Do larger wood lathes have a way to index at different degrees of rotation?

I want to make toy tires for a skid loader design of mine. I want to make the tires

With treads to look like they are earth moving tires.

I will slice the spline shaft like you slice a tomato, and then glue to halves together

with the grooves of each half staggered to give a rough look.

Thanks for any suggestions.

Re: Turned dowel into a spline shaft.

#2

Re: Turned dowel into a spline shaft. *LINK*

John Lucas

I find the Ironfire index wheels to be great. I have one and have put many hours on it. You do have to build some sort of way to hold the index pin but it's not hard and they give you some rough instructions. I don't now if they make one for your lathe but you can check them out. I just started working on a 16 sided fluted pot for a friend and used the index wheel for part of it.


http://www.ironfirellc.com/

Re: Turned dowel into a spline shaft.

#3

Indexing wheel for Powermatic *LINK*

Doc Green

Here is a link to a description of my setup for a PM 3520B.

Click on the photos to enlarge. Click outside the photo to return to the text.

Good Luck, ~Doc


Doc's Indexing Wheel

Re: Turned dowel into a spline shaft.

#4

Here's mine for 3520A powermatic

John Lucas

I simply drilled a couple of holes and tapped them. Screwed a wooden block to the lathe that had holes drilled to match the index wheel. If you want to go all out Alisam indexing plates look really great.



Re: Turned dowel into a spline shaft.

#6

Thanks for your threads

lloyd james

I want to thank all you guys for giving some good directions to go. I had trouble

finding the links that you presented. Thanks again. I better think about getting

a larger lathe, so I don't have to buy 2 of these index discs. :)

I will submit some pics later of my wooden off the road tires.